How to solve this meshing problem in die cating simulation

User: "Pearl"
Altair Community Member
Updated by Pearl

When push the Run command to simulate the dump showed a meshing error. How we can solve this problem? There are the documents in attachment. Thanks in advance.

Find more posts tagged with

Sort by:
1 - 4 of 41
    User: "MilanRaval"
    Altair Employee
    Updated by MilanRaval

    Hello,

    It works fine on my end. To understand better why it failed. I would like you to share your setup in Inspire Cast. Here you have shared only CAD model and image that says meshing failed. Based on that I can not provide more information on cause.

    Regards,

    Milan Raval

    User: "MilanRaval"
    Altair Employee
    Updated by MilanRaval

    image

    User: "Pearl"
    Altair Community Member
    OP
    Updated by Pearl

    Hello,

    It works fine on my end. To understand better why it failed. I would like you to share your setup in Inspire Cast. Here you have shared only CAD model and image that says meshing failed. Based on that I can not provide more information on cause.

    Regards,

    Milan Raval

    I would be delighted if you could tell me how to share my setup on inspireCast because I do not know exactly what I will do.

    Thank you for your help

    Regards,

    User: "Pearl"
    Altair Community Member
    OP
    Updated by Pearl

    image

    i attached the file. Is this the setup file you would like?

    Regards,