Stress results

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hi:

 

I want to know, How I can show the results of stress in .op2 file?, I followed the instructions of tutorial 'Random response analysis of a flat plate' but on Hyperview don't show me results of stress.

I checked that the control card were activated, equal to the tutorial.

 

Please you can help me?<?xml version="1.0" encoding="UTF-8"?>post-36472-0-61352500-1424475907_thumb.j

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited February 2015

    I know nothing about OP2 file.

    But follow these messages, your OP2 does not have any results to load.

  • Rahul_P1
    Rahul_P1
    Altair Employee
    edited February 2015

    FER CM

     

    Please redo the tutorial , make sure you selected OP2 in the format, I just followed the tutorial and I see the results in the op2 file. 

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited February 2015

    ok , thank you I am going to try again.

Categories