The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
How to undo the last command in HyperWorks?
Usually,
Analysis software wont allow users to undo. There is no undo option.
Is there any possibility to undo the last command?
Hi Pradeep,
There is an undo and redo option available in HyperMesh but this does not work for all actions.
It is better to save the model file at periodic intervals to avoid unwanted surprises.
Thank you for the reply Mr.Prakash
