Mesh wing model
Altair EmployeeHi all,
I've been trying to get a wing model from HM to VWT. I've been told that the body I've created thus far is correct (see bottom of post). What I've done is clean up the geometry and created a solid from the bounding surfaces. However, no matter what mesh I create (surface deviation, CFD tetra, etc) when I import into VWT (CFD>Nastran Fluent) there isnt one single volume but four separate ones. This seems to fail when I run the analysis.
Can anyone point me in the right direction.
Regards,
A. John Baker
HM wing model: https://www.dropbox.com/s/5hqmijj3ifwkdi6/defeatured_model%20%281%29.hm
Answers
-
I surface meshed the model in HyperMesh, exported it in Nastran(Fluent) format and brought it into VWT. Worked smooth for me, VWT ran the case and generated a report. Attached is the nas-model I used.
0