pin joint creation
Altair Employeei have created a pin joint with a following steps
> i created one rigid (rbe2) on either side.
> connected independent nodes with 1D beam with pin a =4 and pin b= 0
is that a right way to do it?
and on my main strut lugs..i want to allow the rotation along its axis.. i have done this as in this model attached..
whether what i have done is right or wrong?
Answers
-
Just checked your hm file.Looks like this is not the right way to connect two parts.Will share some relevant information shortly.
0 -
thank u very much sir
0 -
RBE2 should be connected to all dependent nodes & with independent node you can connect bar element.See attached video.
0 -
sir no attachment with this post
0 -
please check now in same comment.
0 -
its there sir.. sorry and thank u very much
0 -
that i can do sir.. connecting independent node to all dependent nodes.. but how to specify degree of freedom on lugs of main strut?
0 -
thank u very much sir..i understood it clearly..
0 -
sir since i want to have a pin joint..in 1d bar element i want to allow the rotation right i.e dof 5 in my problem?
0 -
In v14.0.210 we have a new element RJOINT which can be used to model HINGE/UNIVERSAL/SPHERICAL .
0 -
thats nice sir..but i am doing it in v11.. for the procedure u shown if i give pin a=4 while creating 1d bar will it behave like a pin joint?
0