How do I load, apply results then export model in tcl for Hyperview batch?

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hello, 

 

I am trying to write a tcl script for HyperView to run in batch mode. I need to load my model and results. Apply the results to the final increment and then export the model in a TCL script. None of the hypermesh commands are working and I cannot find HyperView TCL commands. Can anyone explain how this is done?

Tagged:

Answers

  • Rahul Rajan_21763
    Rahul Rajan_21763 New Altair Community Member
    edited November 2017

    Please refer below similar post & let us know if it helps.


     

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited November 2017

    I understand how to call the tcl script from the command prompt. My question is regarding writing those specific commands in the tcl script. Which are basically. 

     

    1. Load the results and model 

    2. deform model 

    3. output model for use in hypermesh

  • Rahul Rajan_21763
    Rahul Rajan_21763 New Altair Community Member
    edited November 2017

    I am moving this topic to HyperWorks scripts and customization section for further support.You can also refer below post.

     

Categories