Can Anyone help me this mesh

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

I am new to hypermesh i had to scale so can use it in hyperworks wind tunnel. i tried automesh to run this model in wind tunnel but it would not mesh. It is an step file. 

I receive a warning saying too many edges. Please Help. Have attached my file. 

 

Thanks

Anand 

 

 

 

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited November 2014

    Hi Anand,

     

    In AutoMesh panel, can you change the meshing mode to Automatic instead of Interactive and check if you still get the same warning.

    <?xml version="1.0" encoding="UTF-8"?>post-7616-0-37314900-1415765281_thumb.jp

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited November 2014

    Hi Anand

    If you have imported it as step file. first delete the solid using Delete>solids.

    While deleting solids, take care that the option 'delete associated surfaces'  is not checked.

     

    Then you will have only surfaces left in the model.

    Now you can perform a automatic geometry cleanup, and then perform a automesh.

     

    Regards

    Meeran

  • Rahul_P1
    Rahul_P1
    Altair Employee
    edited November 2014

    Anand,

     

    Your file is not attached here, please also paste the entire warning/error message. 

     

    Please note that the VWT app requires a watertight surface mesh or as you say it would not continue with the solid mesh,

     

    Please follow the hypermesh checks and meshing procedure in http://training.altairuniversity.com/analysis/cfd/efficient-cfd-meshing-workflow/ 

Categories