The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
I get the following error when i setup the model in Abaqus proile and convert to optistruct profile.
It shows ontact surfaces not selected. But the conversion tool don't ask for any surface selection.
Error Snap in the link below
https://drive.google.com/file/d/0B2rIYPnVjYNEeGo4TDg1NUJqNzg/view?usp=sharing
Ahilan
ahilan,
Can you check if the contact surfaces are selected in the entity state browser?
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…