hv

Altair Forum User

dear sir,

i got the result from nastran but when i am viewing the result in hv i am not able to take the stress wher it is maximum. becouse its showing max at regid joins. shall i take result at tht regid joint or can i mask that and take result in other side

 

Rahul Rajan_21763

Rigids have infinite stiffness.so mask rigid and then contour result for max stress.

 

Regards

Rahul R

Altair Forum User

thank you sir,

i mask all the rigid but it showing max stress where i fix the rigid means i selected the some nodes to connect rigid so in that element i am getting the max stress so

 

Rahul Rajan_21763

If you have created washer modelled with two or three layers then even first layer of elements you can hide & check results.

 

Regards

Rahul R

Altair Forum User

dear sir ,

 i will explain my model

 i did tet second order mesh for that model and its having mass of 7 kg and i lumped 50 kg on that base plate to all edge nodes by path.. when i am viewing result in hv it showing max stress wr i taken the nodes for rbe2.

Altair Forum User

dear sir . i have .op2 file but when i opening in hv .its showing result but the model will not be appear. just once it appear and then it disappear

Altair Forum User

reply me sir

 

Rahul Rajan_21763

Hi,

This behaviour normally happens if you have unconnected part(rigid body motion) in hyperview.You would get higher displacement.

If possible share Op2 file.

 

Regards

Rahul R