NETWORK SIMULATION

Altair Forum User

When i compile the network simulation on my project the software is unable to run it and it says:
-Polygonal result area not possible in this version

-Error in computation of network project. Not all results are computer successfully

The propagation simulation runs. Could anyone help me?

 

Altair Forum User

Hi Roberto,

 

Can you confirm which version you are using?  There was a similar problem with WinProp 14 but the WinProp 14.1 update provided a fix (released end of June).  If you're not using 14.1 or newer, then you can try to update to the latest version.

Altair Forum User

I'm using Winprop 14, how can i update it? should i download it again from the official page or is it possible to download just the updater? thank you for the tip

JIF

Hello Roberto,

 

You need to download the new installation for the Connect website (http://connect.altair.com/). You will find 14.0 and 14.1 is available. Version 14.5 will be released soon (probably next week).

Altair Forum User

i did it but it restitutes ?DialogRuralITU526@@YAHPEAUITU_525_526_PARA@@E@Z as an error and the software does not run

 

MartinV_20771

Hi Roberto,

When upgrading to version 14.1, did you go through the sequence of [Uninstall version 14] [Reboot] [Install version 14.1] [Reboot]?

When you say the software doesn't run, is that just for this particular model or for all models?

If the problem occurs for this model but not for all models, can you upload the problematic model files to this forum so I can have a look?

Regards,

Martin.