No results optained

Altair Forum User

After running the analysis without getting any errors, almost the whole model is plotted in grey for 'no results'. Is there any way to pinpoint the error? I would not mind sharing the files, but I'm not quite sure which ones you need to take a look at it. 

 

Thanks in 

Rahul Rajan_21763

It would be nice if you can share screenshot of HV session & version of Hyperview using at your end?If you have used Radioss or OptiStruct solver for analysis,then please share h3d file using ftin link available in my signature.

Altair Forum User

I used OptiStruct. I shared the file in your dropbox folder among with the screenshots I made using Hyperview 2017.

Altair Forum User

I'm not sure I'm sharing the files properly in your dropbox. Is there anything particular I should be doing, apart from clicking the the link and uploading the files? I'll post these here.

<?xml version="1.0" encoding="UTF-8"?>

Unable to find an attachment - read this blog

Rahul Rajan_21763

You have one component name Auto Skin.Please turn off that component and plot displacement/Stress.Its good to delete skin  element before submission of run. PFA screenshot of stress plot.

<?xml version="1.0" encoding="UTF-8"?>

Altair Forum User

Great thank you very much!! Is there any way I can verify the accuracy of the optained results, other than my own intuition? 

 

 

Rahul Rajan_21763

For FEA results accuracy please refer FEA guide chapter 20.

https://altairuniversity.com/free-ebooks-2/free-ebook-practical-aspects-of-finite-element-simulation-a-study-guide/