Particle tracing and particle concentration

Toon
Toon Altair Community Member
edited October 2020 in Community Q&A

Hi all,

 

I have a question on particle tracing. I want to set up a cfd simulation where an exhaust emits particles. I want to trace these (finite mass) particles and determine the particle concentrations at certain areas. As a bonus it would be nice if I could check the particles which are deposited on a surface near the exhaust.

I want to perform the cfd solution with acusolve while the particle tracing will be done with acutrace. Are the predescribed aspects possible within acusolve and acutrace software?

 

Looking forward to your replies

 

Toon

Tagged:

Answers

  • ydigit
    ydigit
    Altair Employee
    edited June 2020

    Yes it would be possible to particle tracing using AcuTrace for you application. 

    You might want to contact your local Altair Support in case AcuTrace setup gets tricky. 

Categories