meshing problem

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hello , 

I am in an internship and I need your help if it is possible I will be very grateful. Normally I have to do static analyzes on TGV bogies. 1 month ago already that I am planted in the meshing of just the quarter of the bogie  you will find the structure in attached.I find a lot of errors and I can not extract the mid surfaces since there is quite a lot of intersection. I tried to split the solid from each other but I did not get any results. I wait for your advices.Thank you

Cordially , 

 

 

 

 

Tagged:

Answers

  • QuyNguyenDai
    QuyNguyenDai Altair Community Member
    edited April 2017

    I see this kind of structure veru often at work. No choice! You have to do alot of work for surface preparing, sure!

    Good luck!

  • tinh
    tinh Altair Community Member
    edited April 2017

    Yes, it looks impossible for auto midsurface.

    Try creating midsurface per pipe, rib,.. then connect mesh later.

    With professional skill, i think it's estimated to cost ~8H depends on mesh size/quality

  • Rahul Rajan_21763
    Rahul Rajan_21763 New Altair Community Member
    edited April 2017

    Yes first try with auto midsurface then in complex region where auto midsurface fails, try other surface editing options to get mid surface.

Categories