plz do needful...i do not get the output..

Altair Forum User · June 2016

Submitted by Yogesh K on Fri, 02/26/2016 - 16:46

i tried the simple induction motor control programm as per guidance ..but i couldnt get the output plz help me.. i attached the programm below...

thanks ..

Altair Forum User · June 2016

Submitted by pete on Fri, 03/11/2016 - 22:12.

Yogesh, There were several problems with your model.

There was a disconnected gain after your PID that removed the controller from the loop
You were bypassing the PID with another gain
The Voltage Source Inverter was configured to toggle between 0 and 1, but needed to be -1 and 1 to give proper motor response.

The repaired model is attached below.

Answers