To automate press fit analysis in hypermesh using abaqus interface

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Iam working on pressfit analysis in hypermesh using abaqus interface. Typically like like Carrier shaft and hole.

 

I completed the analysis using 1 micron interference radially between shaft and hole.

 

Is it possible for me to increase the interference to 5 micron radially using tcl scripting and postprocess the result without rerunning the simulation?

 

Thanks for any help!! 

Tagged:

Answers

  • tinh
    tinh Altair Community Member
    edited March 2018

    I think if you change your model, you have to rerun the simulation because it is a particularity of fem

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited March 2018

    Thanks!! Can you help me out with TCL scripting to change the interefrence.

Categories