adapting the legend in hyperview

Leire Furundarena
Leire Furundarena Altair Community Member
edited February 2021 in Community Q&A

Hi,

I'm doing a CFD analysis in hypermesh and hyperview but I can't get the results I want in certain sections.

How can I adapt the legend in hyperview to obtain the local maximun value of a section and not the global maximun of the model?

 

Could I get the average value for the velocity in that section, for example?

 

Thanks

Tagged:

Answers

  • Adriano Koga_20259
    Adriano Koga_20259 New Altair Community Member
    edited February 2021

    you can change the selection from 'components' to 'elements' or 'nodes' and select only the ones in your interest area, to get the results ploted only there and also the legend adjusted.

     

    image

  • Leire Furundarena
    Leire Furundarena Altair Community Member
    edited February 2021

    Okey thanks! I could get that but can I get an average value of those nodes?

  • Wesley Castro_21290
    Wesley Castro_21290
    Altair Employee
    edited February 2021
    Leire Furundarena said:

    Okey thanks! I could get that but can I get an average value of those nodes?

    Hi Leire, 

     

    You can use the Matrix Browser to extract result information of all the nodes of interest than take that into excel and find the average. 

     

    Steps: 

    1) Load 'Aerospace Tools' preference file (File -> Load -> Preference File)

    2) Launch Matrix Browser (Aerospace -> Matrix Browser) 

    3) Query nodes of interest from 'HvData' source 

    4) Extract results of interests 

    5) Bring data into excel for further post-processing

     

    I also attached a short video to highlight the workflow. Hope this helps! 

Categories