non uniform distributed pressure/force

mirko088
mirko088 Altair Community Member
edited October 2020 in Community Q&A

Hi, I should create parabolic pressure, how should I set up the equation? the trend must be increasing along the y axis.

Thank you

 

Tagged:

Answers

  • QuyNguyenDai
    QuyNguyenDai Altair Community Member
    edited May 2020

    Applied the pressure by equation?

  • mirko088
    mirko088 Altair Community Member
    edited May 2020

     


    I should apply lift to my blade so I thought of applying it on the surface as a pressure. In this case I should consider a parabolic trend along the wingspan and then use the equation command to give the trend. 
    I know the total force and the area on here to apply it so I can get the total pressure. How can I spread it over this area with a parabolic trend?

  • QuyNguyenDai
    QuyNguyenDai Altair Community Member
    edited May 2020
    Altair Forum User said:

     


    I should apply lift to my blade so I thought of applying it on the surface as a pressure. In this case I should consider a parabolic trend along the wingspan and then use the equation command to give the trend. 
    I know the total force and the area on here to apply it so I can get the total pressure. How can I spread it over this area with a parabolic trend?

     

    Hypermesh gives you a nice possibility to write a mathematical equation to apply the pressure. So this question is about for you, not me :D/emoticons/default_biggrin.png' srcset='/emoticons/biggrin@2x.png 2x' title=':D' width='20' /> 

Categories