Computation Problem with ProMan

Smitha Ramaiah
Smitha Ramaiah Altair Community Member
edited October 2020 in Community Q&A

Hi,

 

I am writing about a problem I have with Altair Feko + WinProp 2019.3 and especially in ProMan. Indeed, I can't display the results of my simulation. This message appears:'Tansmitter was modified. Prediction must be re-computed! Not possible to show the prediction'. And when I restart the simulation, I fall back on the same message. I have a student license. I also specify that my WallMan works.

 

I'd be very grateful if you would help me to resolve this problem.

Please find attached the warning note on the problem of the transmitter and my project.

 

Thank you in advance.

Unable to find an attachment - read this blog

Tagged:

Answers

  • MartinV_20771
    MartinV_20771 New Altair Community Member
    edited June 2020

    I have submitted the problem into Altair's software-defect-tracking system.

  • MartinV_20771
    MartinV_20771 New Altair Community Member
    edited June 2020

    I was able to test it with version-2020-EDU and it works!
    The commercial V2020 became available today; I imagine the EDU version will also be available soon.

  • HrishikeshN
    HrishikeshN Altair Community Member
    edited June 2020

    I am facing the very same problem. I have requested to re-install the new version of WinProp as suggested and am waiting for an input from Altair. Since I already have a pre existing students license for 2019 will there be any problem reinstalling the V2020? Will I have to get a new license? 

Categories