Altair RISE

A program to recognize and reward our most engaged community members

Nominate Yourself Now!

Table_LD_LQ_Light_OnePosition.PFM

I have a reluctance motor on flux 2d and i am trying to find the table from Ld and Lq . I found out that it should be in 3d and i have to run the INIT_AFIR first but the problem it is only defined when i have magnets but in the reluctance motor there isnt any magnets .
can you please help me with finding my way through ?

Ali

Find more posts tagged with

English

Flux

v2022.1.0

Accepted answers

C_Favre

Hi,

The macro Table_LD_LQ_Light_OnePosition.PFM has been developped specifically for Axial Flux Machine, so for 3D project. If I correctly understood you project is 2D ? In this case the macro to use should be CreateLookUpTableFromTMProjectDQLight.PFM developped for 2D project and more especially for PM motor. I have checked the code and for me the macro should work in case of reluctance motor (without magnet)

I hope this helps.

Best regards.

Cyril Favre

All comments

C_Favre

Hi,

I hope this helps.

Best regards.

Cyril Favre

Ali Sawan

Hi,

The macro Table_LD_LQ_Light_OnePosition.PFM has been developped specifically for Axial Flux Machine, so for 3D project. If I correctly understood you project is 2D ? In this case the macro to use should be CreateLookUpTableFromTMProjectDQLight.PFM developped for 2D project and more especially for PM motor. I have checked the code and for me the macro should work in case of reluctance motor (without magnet)

I hope this helps.

Best regards.

Cyril Favre

Thank you Cyril , I have used that Macro and it worked but the output was an .oml file . How do you think the right way to open it ?

I installed Altair compose but it looks like i should learn how to use Altair compose programm to see the result . Is there another way?